Chocochef
2005-03-19 05:57:14 UTC
Due to a stupid error on my part (putting the top burr back in upside
down after cleaning and getting it stuck), I was forced to partially
disassemble my Capresso Infinity grinder. It's fine and all of the
parts are intact (and much cleaner now since they were apart). But I
need some advice for reassembling.
I removed the center holding screw that keeps the bottom burr in place.
When lifting it up along with the bottom burr, 3 small bearings and 3
small springs came loose. I'm not quite sure which order they go back
in. Should the bearings be on the bottom or top? Anyone experience
this in the past or have a diagram they could share?
Please help, I love the grinder and need to get it operational again.
My caffeine levels are way below normal and I don't know if I can wait
until tech support is there on Monday.
BTW, I spoke with Capresso support this morning while at work and they
were very helpful, but my grinder was at home.
Thanks much.
Alex
down after cleaning and getting it stuck), I was forced to partially
disassemble my Capresso Infinity grinder. It's fine and all of the
parts are intact (and much cleaner now since they were apart). But I
need some advice for reassembling.
I removed the center holding screw that keeps the bottom burr in place.
When lifting it up along with the bottom burr, 3 small bearings and 3
small springs came loose. I'm not quite sure which order they go back
in. Should the bearings be on the bottom or top? Anyone experience
this in the past or have a diagram they could share?
Please help, I love the grinder and need to get it operational again.
My caffeine levels are way below normal and I don't know if I can wait
until tech support is there on Monday.
BTW, I spoke with Capresso support this morning while at work and they
were very helpful, but my grinder was at home.
Thanks much.
Alex